Branch:
{{vm.headerLinks.defaultWarehouse.linkText}}Pending Approvals:
{{vm.headerLinks.pendingApproval.linkText.split(" ")[0]}}Open Orders:
{{vm.headerLinks.openOrders.linkText.split(" ")[0]}}Product Lists:
{{vm.headerLinks.productList.linkText.split(" ")[0]}}
BRADFORD WHITE RG1PV50S6N 50 GAL POWER VENT NATURAL GAS WATER HEATER
Bradford White® Residential Gas Water Heater, Model TTW, 50 gal Heating, 11.7 kW, Natural Gas Fuel, 1/2 in Gas Connection, 3/4 in NPT Water Connection, Power Vent, 2 in Vent, Magnesium Anode Rod Heating Element, 80% Energy Efficiency, 43 gph Recovery Rate, 150 psi, Ultra Low NOx: Yes, Steel
MANUFACTURER DISCLAIMERS:
-
Bradford White manufactures products for installation by qualified professional contractors with applicable state and local licensing. Bradford White Corporation assumes no liability for products installed outside of the installation recommendations in the product’s official installation and operation instruction manual. Bradford White only assumes responsibility for verified manufacturing defects as stated in the applicable Bradford White limited warranty for your product.
-
It is the purchaser’s responsibility to purchase products that meet state and local codes for the intended installation site of the Bradford White product.
- Features
- Intelligent gas control with spark to pilot ignition system eliminates the constant burning pilot
- Proprietary algorithms provide enhanced first hour delivery ratings and tighter temperature differentials
- Microprocessor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels
- An exclusive green LED light prompts the installer during startup and provides 10 different diagnostic codes to assist in troubleshooting
- Sight window offers a view into the combustion chamber to observe the operation of the pilot and burner
- An exclusively engineered enamel formula that provides superior tank protection from the highly corrosive effects of hot water, this formula (Vitraglas®) is fused to the steel surface by firing at a temperature of over 1600 deg F
- Non-CFC foam covers the sides and top of the tank, reducing heat loss, this results in less energy consumption, improved efficiencies and jacket rigidity
- Temperature and pressure relief valve included
- Durable tamper-proof design low restriction brass drain valve
- Protective magnesium rod
- Factory installed heat traps design incorporates a flexible disk that reduces heat loss in piping and eliminates the potential for noise generation
- Factory installed Hydrojet® total performance system
- Advanced ScreenLok® technology flame arrestor is designed to prevent ignition of flammable vapors outside of the water heater
- Designed for installations where atmospheric units cannot be used
- Our significantly quiet design has greater resistance to outside winds and the power to vent in many difficult venting situations
- Electronic sensor prevents burner operation if flammable vapors are detected
- No regular cleaning of air inlet openings or flame arrestor is required under normal conditions
- STANDARD_APPROVALS: AHRI Certified, CEC Listed, CSA 4.1-M, Meet or Exceed ASHRAE 90.1b, ANSI Z21.10.1